S&s Cycle Cam - 33-5064 For Harley Motorcycles 1978-1984 Brand_D'cor Visuals three extra sets of terminal

three extra sets of terminal wires

Rick's uses a 6 mm stud and nut which may make it necessary to open up the terminal at the end of the starter cable with a 1/4" drill

For all '07-'17 Twin Cam and '06 Dyna

replace stock HD knobs with safety bolts without using U-Nuts

Protection from corrosion and wear

S&s Cycle Cam - 33-5064 For Harley Motorcycles 1978-1984 Brand_D'cor Visuals three extra sets of terminalFeatures S&S cams are tested on the dyno, street and racetrack before being offered to the public With hundreds of test hours on them, you know that you are getting the best cam S&S can produce Good low and mid range torque Bolt in cam for lower compression motors with compression up to 8. 5: 1 Recommend hydraulic lifters Made in the USA Installer must check coil bind, valve to valve clearance, valve to piston clearance and cam lobe to case clearance.