Flywheel/Pulley Holder - Tusk grips IMPORTANT NOTE: Any bore kit

IMPORTANT NOTE: Any bore kit for the Z125 must be used with an aftermarket fuel controller to prevent a lean condition and damage to your engine

Lighter than stock

Kit contains all necessary O-rings and diaphragms to rebuild one fuel petcock

VM26 by Mikuni is built with quality materials for consistent

oil seal - see picture)

Flywheel/Pulley Holder - Tusk grips IMPORTANT NOTE: Any bore kitFlywheel Pulley Holder Tusk Details The Tusk Flywheel Pulley Holder is designed to hold a 60mm 120mm flywheel to make the removal and installation of your flywheel simple and easy. Two adjustment holes in the belt make it easy to adjust to different sizes. Easily adjustable to fit a 60mm 120mm (2 3 8" 4 3 4") flywheels. Tough plastic belt holder won't mark surfaces. Suitable for flywheel and clutch pulleys on a large range of motorcycles and ATVs